Beta Marine Beta 10 Operator's Maintenance Manual page 31

Problem: Low power output
Possible Cause
Propeller is too big:
Check gearbox reduction ratio relative to propeller size:
Blocked fuel filter:
Blocked air filter:
Air in fuel system:
Governor spring incorrectly mounted:
Single lever control not operating correctly:
The electrical load is too large on start up:
Problem: Erratic running / hunting
Possible Cause
Air in fuel supply:
Fuel lift pump faulty:
Clogged fuel filter:
Fuel return not fed back to the fuel tank, or blocked pipe:
Air filter blocked:
Worn or blocked injector:
Engine rpm in gear is too low, this must be 850 min:
Faulty stop solenoid:
Broken fuel injection pump spring:
Fuel suction head is too much:
Problem: Hunting at idle
Possible Cause
Idle adjustment screw may need adjusting:
Problem: Hunting at higher speeds
Possible Cause
Fuel supply problem:
Problem: White or blue exhaust gas
Possible Cause
Engine oil level too high:
Blocked injector:
Piston ring and bore worn or con rod bent due to water
ingression, giving a low compression:
Check that the breather pipe is clear and not obstructed:
Solution
Change or depitch.
Change.
Replace.
Replace.
Check system and bleed
Dealer to adjust.
Disconnect speed control cable and move the lever
by hand. Adjust cable.
Disconnect or reduce the load.
Solution
Check supply system for leaks and fix.
Replace.
Replace.
Re-route pipe or clean.
Replace.
Service injectors.
Increase engine tick over speed.
Disconnect wiring to solenoid. If running improves
check for a wiring fault.
Replace, this is usually caused by water in the
engine oil/fuel
Fit electric fuel lift pump.
Solution
speak to Beta Marine for advice with idle adjustment
- discuss problem.
Solution
Change fuel filters and check fuel supply.
Solution
Reduce the level.
Service injectors.
Get compression checked by your dealer or
Kubota service agent. He will advise action to be taken.
Remove and clean out
29