Removing The Drive - JVC MC-8100U Service Manual

2.1.4 Removing the Drive

1. Open the door. (Refer to 2.1.2.)
2. Remove the side cover (R). (Refer to 2.1.8.)
3. Remove the rear panel. (Refer to 2.1.9.)
4. Disconnect the two connector cables from the drive.
5. Disconnect all the SCSI cables from all the drives and the
SCSI PCB. (When removing the drive in the uppermost slot
among the currently mounted drives, disconnect the cable
connected to the uppermost drive only.)
Photo shows situation when removing the Drive 2
1
6. Remove the screw located on the side of the drive (door
panel side).
Photo shows situation when removing the Drive 2
7. Remove the drive from the rear.
2.1.5 Removing the side stay R
1. Open the door. (Refer to 2.1.2.)
2. Remove the C panel. (Refer to 2.1.2.)
3. Remove the side cover R. (Refer to 2.1.8.)
4. Remove the four screws
Connector cable
SCSI cable
Note:
Side stay R must be removed when removing the carrier
mechanism.
1
MC-8100U
2
to remove the side stay R.
2
2-4