Table of Contents
Advertisement
2.3.3 Erasing the Trouble History
The error history can be cleared by pressing ENTER key for more than 5 seconds during displayed error history.
2.3.4 Error code list
Device
Error
Device
part
code
01
02
03
C
U
04
05
08
09
10
C
L
11
12
20
21
22
23
24
25
C
C
26
27
28
29
30
31
*2
41
C
D
42
43
80
F
81
E
50
M
L
51
T
52
60
T
61
C
62
(D#)
E
63
*1
D
64
S
65
P
T
72
*1: # represents the drive number.
*2: Check the magazine loading condition.
UP/DOWN rotary sensor does not change
Left slit sensor does not change
Right slit sensor does not change
UP/DOWN motor does not function
UP/DOWN motor doesn't work correctly or rotary sensor defective
UP/DOWN operation exceeds the predetermined duration
Upper or lower limit sensor turn on during UP/DOWN operation
Tray lock release not possible
Tray lock impossible, or lane change not possible
Tray lock does not exist at the initial position during carrier movement
a
Catcher (right
left) movement operation exceeds the predetermined duration
a
Catcher (left
right) movement operation exceeds the predetermined duration
a
Catcher (right
left) convergence operation exceeds the predetermined duration
a
Catcher (left
right) convergence operation exceeds the predetermined duration
a
Catcher (right
left) tray rotary sensor does not change
a
Catcher (left
right) tray rotary sensor does not change
Right catcher sensor does not turn on
Left catcher sensor does not turn on
a
Catcher motor (right
left) does not function
a
Catcher motor (left
right) does not function
Tray does not exist
Magazine insertion incomplete, or sensor defective
Destination-unknown tray exists on the carrier
No disc in the tray
Flip tray does not exist
During the flip raise operation, the expected time required is over
During the flip descent operation, the expected time required is over
Mail Slot ejecting is not possible
Mail Slot loading is not possible
Destination-unknown tray exists in the Mail Slot
Destination-unknown tray exists in the Drive and the control cable of the Drive is disconnected.
Tray removal is not possible at the drive position
Disc clamp of the drive does not function
Drive ejection is not possible
Failure to remove the disc from the drive
Spindle motor fails to stop
Destination-unknown tray exists in the Label Printer
Description
MC-8100U
2-18
Advertisement
Table of Contents
