Recovery From Usb Flash Drive - Toshiba IP edge EP Installation Manual

EP SERVER RESTORE
Recovery From USB Flash
Drive
Installation Manual August, 2011
Note: If an error occurs in step 4 remove then, insert the USB flash
drive then, try step 4 again.
5. Remove the USB flash drive.
6. Download IPedge EP server ISO image file and zip file from Toshiba's
FYI website to the adminisrator PC.
7. Insert the USB flash drive into the administrator PC.
8. Extract the zip file to USB flash drive and copy ISO image file to USB
flash drive.
9. Remove the USB flash drive from the PC.
Administrator can install the IPedge EP server recovery software image
using the following procedure. This procedure requires that the IPedge
EP server be connected to a network with internet access and the
following hardware.
• USB Keyboard
• Monitor
• USB flash drive prepared using the procedure above with the IPedge
EP software.
Important! Before starting this procedure use a PC to perform a
virus test on the USB flash drive.
1. Power down the IPedge server.
2. Connect the IPedge EP server to the network (required for HMP
Setting during recovery).
3. Connect the keyboard, monitor and the USB flash drive to the IPedge
EP server.
4. Power on the IPedge EP server.
5. Press the F12 key on the keyboard to select boot device during
memory test display.
6. Use the keyboard cursor keys to highlight "USB" and press the Enter
key.
7. When the Red Hat Enterprise Linux window appears press the Enter
key to launch recovery process.
8. After recovery procedure is successfully done a Linux screen with a
message; the installation is complete will appear. Verify that
Installation Successful is displayed.
9. Remove the USB flash drive.
10. If necessary press the tab key to highlight the Reboot button then
press Enter. The system will reboot. If the reboot button is not visible
press Alt + F6 to change the screen.
Important! You must remove the USB flash drive before you reboot
the system.

Recovery From USB Flash Drive

16-9