EM SERVER RACK MOUNT
EM SERVER RACK
MOUNT
Rack Mount Kit
Installation
Figure 2-8 Four-Post Rail Kit
2-10
The IPedge EM Server is 25.6 inches (650 mm) deep. The included
mounting rails are designed for installation in four-post racks and
cabinets.
CAUTION! The IPedge EC and EM servers must only be installed in
an equipment rack using the mounting rails. The single
screw on each side of the front panel only secure the
chassis on the rails. They are not weight bearing.
The rack mounting kit consists of two sections: an inner fixed chassis rail
that secures directly to the server chassis and an outer fixed rack rail that
secures directly to the rack itself. Refer to
The server chassis includes a set of inner rails in two sections: inner rails
and inner rail extensions. The inner rails are pre-attached and do not
interfere with normal use of the chassis if you decide not to use a server
rack. Attach the inner rail extension to stabilize the chassis within the
rack.
Rack Mount Kit Installation
Figure
2-8.
Installation Manual
August, 2011