Table of Contents
Advertisement
SET SYSTEM TIME
SET SYSTEM TIME
Installation Manual
August, 2011
The following steps set the system time and assign the Network Time
Protocol server pool. An NTP pool provides access to several NTP
servers. This helps ensure that one or more servers is always available.
All of the nodes in a multi-node system should synchronize to the same
NTP pool. It is critical the time in each node is the same, within several
seconds, as the other nodes.
1. Login to Enterprise Manager. Select Application > Webmin.
2. Select Hardware > System Time then, click on the Set time tab. Set
the system time to the current correct time. This must be within a few
minutes of the local correct time. A cell phone is an easy way to
display the current time.
3. Click on Apply.
4. Click on the Set hardware time to system time button. Verify the
Hardware time is the same as the System time you just entered.
5. Click on Save.
6. In the Change timezone tab set the local time zone.
7. In the Time server sync tab enter the Timeserver hostname. Use an
NTP pool. Toshiba recommends that the system sync to an NTP pool
once each day. In the example below a local region NTP pool (north-
If Webmin Stops Responding
4-7
Hide quick links:
Advertisement
Table of Contents
