Setting Communications Without Using Docomo Connection Manager - Fujitsu Docomo F-07F Instruction Manual

Setting communications without using DOCOMO
Connection Manager
The method of dialup connection setup without DOCOMO Connection Manager is explained.
Flow of dialup network setting
Flow of setup for data communication
Before operating, make sure that a PC and FOMA terminal are properly connected.
When the access point is mopera U or mopera, you do not need to set.
* Set for packet communication.
Terminal software to input AT commands is required for settings. Set using the software supported by
each OS (follow the method for the terminal software to be used).
Setting the dialup connection (APN)
❖
The dialup connection (APN) and registration number (cid)
The dialup connections (APN) for packet communication can be set up to 10 items for registration numbers
(cid) between 1 and 10 in FOMA terminal. By default, "mopera.net" (APN) to connect to mopera U is
registered in cid1 and 3, and "mpr.ex-pkt.net" (APN) to connect in 128K communication is registered in cid4.
For connecting to other providers or corporate LANs, register APN for cid2, 5-10.
For the dialup connections (APN), inquire your provider or network administrator.
For USB cable connection and Bluetooth connection, setting each dialup connections (APN) is required.
For packet communication, if switching between USB cable connection and Bluetooth connection,
setting the dialup connections (APN) is required again.
The dialup connection settings can be considered as phonebook entries registered for packet
communication. The comparison between dialup connection settings and FOMA terminal phonebook is
as shown below.
Connection (APN)
Registration number (cid)
Connection name (APN)
99 <cid># (packet
communication)
The registered cid become the connection number in the dialup connection numbers setting.
❖
Setting the dialup connection (APN)
1
Activate the terminal software to enable AT command input.
2
Enter the dialup connection (APN) in the format "AT+CGDCONT =<cid>,
"<PDP_TYPE>", "<APN>""
P4
Setting the dialup connection (APN)
Setting Show/Hide caller ID
Set as required.
Setting Dialup Network P17
Phonebook item
Registration number (Phonebook
No.)
Party's name
Party's phone number
15
*
P15
*
P16