Fujitsu Docomo F-07F Instruction Manual page 120

List of AT command
The followings are AT command that can be used via the FOMA F07F (Modem).
Entering " " may cause "\" to appear depending on the font setting for a PC or communication software.
If the battery pack is removed from FOMA terminal before the terminal power is turned off, the setting
values may not be recorded.
Upper slot : Command
Lower slot : Example
A/
A/
OK
AT
AT
OK
ATA
RING
ATA
CONNECT
ATD
ATD 99 1#
CONNECT 460800
*1
ATE<n>
ATE1
OK
ATH
ATH
NO CARRIER
ATI<n>
ATI0
NTT DoCoMo
OK
ATO
ATO
CONNECT 460800
*1
ATQ<n>
ATQ0
OK
*1
ATS0=<n>
ATS0=0
OK
ATS2=<n>
ATS2=43
OK
ATS3=<n>
ATS3=13
OK
Execute the previously executed command again.
When previous response is "ERROR", "ERROR" is returned.
Use commands on this list by prefixing to commands other than A/ or +++. When using
only this command, "OK" is returned with FOMA terminal enabled for using AT
commands.
Perform the receiving process when entered while receiving a packet communication or
64K data communication.
The following commands can be entered when receiving a packet communication.
ATA184 : Handling of incoming calls : Send caller ID function OFF
ATA186 : Handling of incoming calls : Send caller ID function ON
ATD 99 <cid># : Performs calling process for packet communication.
If <cid> or <cid> is omitted, <cid>=1 is set.
ATD [parameter] [phone number] : Perform calling process for 64K data communication.
Calling process is not permitted if phone number contains characters other than the
following.
0-9, , #, A, a, B, b, C, c
The following characters and a space can be entered but are not recognized in dialing.
,(comma), !, -, @, D, d, P, p, T, t, W, w
Setting Show/Hide caller ID is enabled by inserting 186 or 184 after ATD.
ATDN or ATDL can be used for redial calling.
Set whether FOMA terminal will return echo for command sent from a PC.
n=0 : Echo OFF n=1 : Echo ON (default)
Normal usage is n=1. If the PC has an echo function, setting this command to n=0 prevents
double display of characters.
Disconnect line when entered during a communication.
Execute in online command mode.
Display the confirmation code.
n=0 : "NTT DoCoMo" n=1 : Display model name of FOMA terminal
n=2 : Display version of FOMA terminal
n=4 : Display details of functions that can be communicated by FOMA terminal in numeric
Return from online command mode to online data mode during communication.
Set whether to display result code.
n=0 : Display (default) n=1 : Not display
When ATQ1 is executed, "OK" is not returned.
Set number of rings until FOMA terminal receives communication automatically.
n=0 : Not receive automatically (default)
n=1-255 : Receive automatically with specified number of rings
ATS0? : Display current settings
Set escape character.
n=0-127 (default : n=43)
ATS2? : Display current settings
Set the carriage return (CR) character that identifies the end of AT command character
string. Appended to end of echoed command character string and result code.
n=13 (fixed value)
ATS3? : Display current settings
26
Description
P25
n=3 : Display elements of ACMP signals
When n=127 is set, escape is unavailable.