Brother 09055CDN Service Manual page 70

Code 1 Code 2
A8 01
A9 01
AA 18
B0 02
B0 03
B0 04
BF 01
BF 02
BF 03
C0 01
C0 02
C0 03
C0 04
C0 10
C0 11
C0 20
C0 21
C0 22
C0 30
C0 31
FF XX
*1
Available in German models only.
*2
Establishment of FAX communication:
FAX communication is established when the calling station receives a DIS (reception
capability) signal from the called station and the called station receives a NSS or DCS
(communications test) signal from the calling station.
RTN, PIN, or ERR received at the calling terminal.
RTN, PIN, or ERR received at the called terminal.
Receive buffer full during receiving into memory.
Unable to receive the next-page data.
Unable to receive polling even during turn-around
transmission due to call reservation.
PC interface error.
Communication canceled by pressing the Stop/Exit button
before establishment of FAX communication.
Communication canceled by pressing the Stop/Exit button
after establishment of FAX communication.
Transmission canceled due to a scanning error caused by
no document or document feed problem in ADF scanning
in real time transmission.
No common modulation mode or failed to poll.
Unable to detect JM.
Unable to detect CM.
Unable to detect CJ.
Cannot finish V. 34 negotiation or training.
Modem error detected during V. 34 negotiation or training.
Modem error detected during sending of commands.
Modem error detected during receiving of commands.
Control channel connection time-out.
Modem error detected during sending of video signals.
Modem error detected during receiving of video signals.
Equipment error
(For X X, refer to "3.1 Error Codes" in this
2-31
Cause
*2
*2
chapter.)
Refer to:
*1
2-138
*1
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
2-138
Confidential