Installing The Dualpoint Integrated Pointing Device Drivers; Installing The Touch Pad Drivers (Windows 2000) - Dell Inspiron 3800 Reference And Troubleshooting Manual

support.dell.com
5. Set the Screen area for your display to the appropriate size.
6. Click OK.
Installing the DualPoint Integrated Pointing Device
Drivers (Windows 2000)
DualPoint integrated pointing device drivers and associated utilities allow you to use
and customize the integrated touch pad, track stick, or external mouse. To install
these drivers, perform the following steps.
NOTICE: Use these steps to install touch pad drivers only if your computer
has a track stick. If your computer does not have a track stick, follow the
instructions in the next section, "Installing the Touch Pad Drivers."
1. Save your work in all open application programs because you will need to restart
your computer at the end of this procedure to complete the installation.
2. Insert the System Utilities CD into the CD-ROM drive.
3. Click the Start button, and then click Run.
The Run dialog box appears.
4. Type x:\win2000\touchpad\dual\setup, where x is the drive letter of your
CD-ROM drive, and click OK or press <Enter>.
5. Follow the instructions on the screen.
6. After the files are copied to your hard-disk drive, remove the System Software CD
from the CD-ROM drive, and click Finish to restart your computer.

Installing the Touch Pad Drivers (Windows 2000)

Touch pad drivers and associated utilities allow you to use and customize the inte-
grated touch pad or external mouse. To install these drivers, perform the following
steps.
NOTICE: Use these steps to install touch pad drivers only if your computer
does not have a track stick. If your computer has a track stick, follow the
instructions in the previous section, "Installing the DualPoint Integrated
Pointing Device Drivers."
1. Save your work in all open application programs because you will need to restart
your computer at the end of this procedure to complete the installation.
2. Insert the System Software CD into the CD-ROM drive.
3. Click the Start button, and then click Run.
The Run dialog box appears.
4. Type x:\win2000\touchpad\single\setup, where x is the drive letter of
your CD-ROM drive, and click OK or press <Enter>.
System Software Solutions 4-19