Service and Repairs
NOTE: For more component testing information, see
the Briggs and Stratton Vanguard Service and Re-
pair Manual for 4–Cycle, V–Twin Cylinder, OHV En-
gines or the Kohler Service Manual for Command
Pro CS Series Engines.
Headlights
Specification: GE Headlight #H7610
1. Set parking brake, turn ignition off, and remove key.
2. Reach beneath dash and push headlight out of the
hood.
3. Remove screws attaching the wire harness to the
headlight.
4. Remove rubber seal from around the headlight. Dis-
card headlight.
5. Align notch on the inside of the seal with the notch on
the new headlight. Slide seal onto the headlight until the
seal is firmly in place.
6. Attach headlight to the wire harness using the pre-
viously removed screws.
NOTE: Applying soapy water to the outside of the seal
may aid in sliding the seal into the hood.
7. Align notch on the outside of the seal with the notch
in the hood. Push headlight and seal into the hood until
it is firmly in place.
Workman 1100/1110/2100/2110
3
2
4
1. Rubber seal
2. Inside notch
Page 6 – 15
1
Figure 18
3. Outside notch
4. Headlight
Electrical System