Toro Workman 1100 Service Manual page 78

1. Differential assembly
2. Input shaft assembly
IMPORTANT: Make sure not to damage the oil seal
when removing the input shaft.
Note: If any of the assemblies can not be pulled out by
hand, hold the assembly while gently tapping the case
with a plastic hammer. Make sure to tap equally around
the case.
3. Remove axle case from case (RH and LH).
1. Flange bolt
2. Axle case
A. Remove flange bolts securing each axle case to
the case. Remove axle case from the case.
Drive Train
3
4
2
1
3
Figure 36
3. Center shaft assembly
4. Shift shaft
G. Lift up differential assembly, center shaft assem-
bly, and input shaft assembly at the same time. First,
remove input shaft assembly. Then, remove center
shaft assembly with the shift shaft and differential as-
sembly.
Figure 37
3. Case
Page 5 – 24
1
2
Workman 1100/2100/2110