Figure 44 - Toro Workman 1100 Service Manual

6
1. Gear 55
2. Gear 47
3. Gear (small)
4. Ball bearing
5. Ball bearing
B. Remove gears, pin clutch, collars, and spacer
from the input shaft.
C. Replace gears if worn or damaged. Cracked, bro-
ken, missing, or chipped gear teeth are not accept-
able.
D. Replace center shaft if worn or damaged. Splines
that are cracked, broken, chipped or missing are not
acceptable.
Drive Train
8
5
7
1
3 8

Figure 44

6. Pin clutch
7. Center shaft
8. Collar
9. Spacer
E. Replace pin clutch if cracked or bent.
F. Ball bearing roller balls must be free of deforma-
tion and scoring. Ball bearings must spin freely and
have minimum axial play. Replace ball bearings as
necessary.
G. Replace collars or spacer if excessively worn or
damaged. Replace both collars as a set.
Page 5 – 28
2
1
4
9
Workman 1100/2100/2110