Figure 75 - Toro Workman 1100 Service Manual

1. Governor shaft
Note: When installing case (RH) to the case (LH), hold
governor shaft so the ball bearing will not drop off. Keep
the gasket sealing surfaces of the cases as horizontal to
each other as possible. If the sealing surfaces do not join
to each other, tap the case lightly with a plastic hammer.
1. Axle bracket
E. Position axle bracket to each axle case. Secure
axle bracket to each axle case with flange bolts.
Torque bolts from 25 to 31 ft–lb (34 to 42 N–m).
Workman 1100/2100/2110
1
2
15 to 18 ft–lb
(21 to 25 N–m)

Figure 75

2. Bolt
C. Install case (RH) so each shaft fits properly into
the case.
D. Secure case (RH) to case (LH) with bolts. Torque
bolts from 15 to 18 ft–lb (21 to 25 N–m).
25 to 31 ft–lb
(34 to 42 N–m)
1
Figure 76
2. Flange bolt
Page 5 – 45
2
Drive Train