Toro Workman 1100 Service Manual page 54

Hide thumbs Also See for Workman 1100:
Table of Contents

Advertisement

Engine Installation (Fig. 17)
1. If removed, install engine parts and attachments to
the engine.
CAUTION
One person should operate the chain fall or hoist
while the other person guides the engine into the
frame.
2. Install engine to the frame.
A. Attach a short section of chain between fuel
pump bracket lift hole and exhaust manifold (Fig.
18).
B. Connect a hoist or chain fall at the center of the
short section of chain.
IMPORTANT: Make sure not to damage engine, fuel
lines, electrical harness, or other parts while instal-
ling the engine.
C. Lower engine into the engine mount.
3. Route ground cables to proper mounting point. Se-
cure engine to the engine mount with four flange lock
nuts and flange head screws.
4. Connect engine harness connector to the main har-
ness connector.
5. Install starter bracket to the engine and frame.
6. Install V–belt to the engine and starter/generator.
Tension and adjust the V–belt (see Adjust Starter/Gen-
erator Belt).
Kohler Gasoline Engine
7. Install drive belt (see Service Drive Belt).
8. Install muffler and coupler to the exhaust manifold
(see Muffler Removal).
9. Connect fuel hose to the fuel pump (Fig. 18).
10.Connect the following components:
IMPORTANT: Make sure all hoses and engine open-
ing plugs are removed.
A. Choke and throttle cables to the carburetor and
cable bracket.
B. Air intake hose to the carburetor.
C. Breather hose to the engine valve cover.
11. Secure choke and throttle cables to the fuel pump
bracket with cable tie.
12.Connect positive (red) cable to the battery. Then,
connect ground (black) cable to the battery.
13.Install cargo bed to the frame (see Cargo Bed and
Tailgate Installation – Chapter 7).
14.Make sure engine oil level is correct (see Check En-
gine Oil).
15.When starting a new or repaired engine, observe the
following:
A. After starting a cold engine, let it warm up for
about 15 seconds before applying any load to it.
B. Check engine oil level regularly. Be alert for con-
ditions of overheating.
Page 4 – 16
Workman 1100/1110

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Workman 1110Workman 2100Workman 2110

Table of Contents