Rack installation
Preparing the UPS for rack mounting
About this task
Note: This step requires two people.
The UPS is heavy. To ease its rack mounting, you can remove the battery packs
from the UPS as explained below.
Procedure
1. Remove the center cover of the front bezel.
2. Loosen the two screws to open the left side of the front bezel.
3. Remove the two screws to pull out the metal protection cover of the battery
4. Pull out the plastic handle of the battery pack, and slide the packs out slowly
pack.
Note: A ribbon cable connects the LCD control panel to the UPS. Do not pull
on the cable or disconnect it.
on to a flat and stable surface. Use two hands to support the battery packs. Set
them aside for reinstalling after that the UPS is rack mounted.
21
Chapter 3. Installation