Sharp AL-2020 Service Manual page 104

Main Sub
Contents
code code
26 43 Side void setup
γ life correction setting
54
62 Energy-save mode copy
lamp setup
30 01 Paper sensor status display
[Function]
When this simulation is executed, the currently set code of the side void quantity is displayed
(initial display), and the set data are saved. (Setting range: 0 – 10, Default: 4 (= One side
2.0mm))
Code
0
1 0.5 mm
2 1.0 mm
3 1.5 mm
4 2.0 mm
5 2.5 mm
6 3.0 mm
7 3.5 mm
8 4.0 mm
9 4.5 mm
10 5.5 mm
* When the adjustment value is increased by 1, the side void is changed as follows:
Side void adjustment: The side void is increased by 0.5mm. (The side void of "Set value x
0.5mm" is made.)
[Operation]
The operation is similar to simulation 09-04.
[Function]
Used to set the γ life correction.
When this simulation is executed, the current set code number is displayed.
Enter the desired code number and press [OK]/[START] key to save the setting.
(Setting range: 0 – 1, default: 1)
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
Used to set half-ON /OFF of the copy lamp in the pre-heat mode.
When this simulation is executed, the current set code number is displayed. Enter the desired
code number and press [OK]/[START] key to save the setting.
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
The paper sensor status is displayed on the LCD/LED.
Sensor
Paper exit sensor
Paper entry sensor
Duplex sensor
New drum cartridge sensor
∗ Since the manual paper feed sensor is a single bypass sensor, its status is not displayed.
∗ The width sensor is available only in the FAX models.
[Operation] (AL-2050/2060)
1) Initial display
30-01 P-SENSOR
AL-2020/2035/2040/2050/2060 SIMULATION, TROUBLE CODES 10 - 14
Details of function/operation
Setting Remark
0 mm
Default
Setting
OFF
ON
Setting
Copy lamp OFF
Copy lamp half-ON
Display item
(AL-2050/2060)
POD
PPD1
PPD2
DRST
2) When sensor ON
30-01 POD
PPD1 PPD2 DRST
Display item Remark
OFF
ON Default
Display item Remark
OFF
ON Default
Display lamp
(AL-2020/2035/2040)
Photoconductor cartridge replacement lamp
Developer cartridge replacement lamp
JAM lamp
Zoom lamp
PD1 PD2