Sharp AL-2020 Service Manual page 137

Program
Program name
number
12 MARGIN WIDTH
13 MEM. FOR
PRINTER
14 AUTO KEY
REPEAT
15 KEY PRESS TIME
16 KEY TOUCH
SOUND
17 SOUND AT
DEFAULT
18 TONER SAVE
MODE
19 AE LEVEL
ADJUST
20 LANGUAGE
21 RESET FACTORY
22 SORT AUTO
SELECT
24 CHECK RSPF
OPEN
25 VALID COPY
WIDTH
28 LSU SETTING
29 PAPER TYPE
30 DISPLAY
CONTRAST
Setting codes
(factory default setting
appears in bold)
1: 1/4" • Use this setting to set the margin width.
2: 1/2"
3: 3/4"
4: 1"
1: 30% • Use this to change the proportion of machine memory used for printer mode.
2: 40%
3: 50%
4: 60%
5: 70%
1: ON • Use this setting to select whether or not holding down a key causes repeated
2: OFF
1: NORMAL • Use this setting to select how long a key must be pressed for the input to be
2: 0.5 SEC.
3: 1.0 SEC.
4: 1.5 SEC.
5: 2.0 SEC.
1: LOW • This sets the volume of beep signals.
2: HIGH
3: OFF
1: ON • Use this to sound a beep when a base setting is selected.
2: OFF
1: ON • This mode reduces toner usage by about 10% when copying. Toner save
2: OFF
1: SPF/RSPF • This is used to adjust the exposure level.
(Adjustment to • The automatic exposure level can be adjusted separately for the document
5 levels is possible.)
2: DOCUMENT GLASS • For the procedure for adjusting the exposure and guidelines for numeric
(Adjustment to
5 levels is possible.)
1: AMERICAN ENGLISH • This is used to set the language used in the display.
2: ENGLISH
3: FRENCH
4: SPANISH
1: YES • This is used to return all settings to the factory default settings.
2: NO
1: ON • Use this setting to enable or disable sort auto select mode.
2: OFF
1: ON • You can set the operation that takes place if the [START] key (
2: OFF
1: 8.5x11 • Set the allowed paper sizes for copying from the bypass tray. When "5.5x8.5"
2: 5.5x8.5
1: ON • Select whether copying is only allowed when the polygon motor is rotating, or
2: OFF
1: PLAIN PAPER • Set the temperature of the fusing unit when the bypass tray is used. Normally
2: HEAVY PAPER
1: LIGHTER • Set the contrast of the display.
2: LIGHT
3: NORMAL
4: DARK
5: DARKER
AL-2020/2035/2040/2050/2060 USER PROGRAM 11 - 3
input of the key. For keys that normally cause a set value to decrease or
increase when held down (for example, the [
( )), this program can be used to have the set value not change when the
key is held down.
accepted.
By selecting a longer time, you can prevent settings from being changed by
the accidental pressing of a key.
mode is effective when the exposure mode is AUTO or TEXT.
glass and the RSPF.
values. The factory default setting for the exposure level is center.
when the RSPF is not completely closed.
is selected, a copy of a letter size original will only be printed up to invoice
size.
also when the polygon motor is stopped.
"PLAIN PAPER" should be selected.
Explanation
] key ( ) or [ ] key
) is pressed