Panasonic KX-TD500 System Reference Manual page 286

10.02 DTMF Tone Integration
Description
Programming
When the parameter "DTMF-Tone Intergration" is set to "Y" by system
programming, the KX-TD500 system sends codes (DTMF tones) to the
Voice Processing system to indicate the status of the call (busy,
answered, ringing, disconnect, etc.) in addition to the normal call progress
tones. These codes enable the Voice Processing system to immediately
recognize the current state of the call and improve its call handling
performance. These codes apply to all incoming calls: Outside calls only
indicate disconnect (provided the KX-TD500 system is programmed
properly for CPC detection and the Central Office sends the CPC signal).
1) Press CTRL key and V key simultaneously when Main Menu
screen is displayed at VT programming mode.
2) Enter P R G and press Return key when Dumb programming
mode initial prompt (;>) is displayed. Then programming mode initial
prompt (; PRG>) is displayed on the screen.
3) At the programming prompt (PRG>), type:
; PRG > WS3 AT 03
The screen displays the Input prompt (INPUT >>) as follows:
; PRG > WS3 AT 03
; 3 : DTMF-Tone Integration.............. N
; INPUT >>
4) At the Input prompt (INPUT >>), type:
; PRG > WS3 AT 03
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
5) The screen displays the Input prompt (INPUT >>) for Item 1 as
follows:
; PRG > WS3 AT 03
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
; 1 : DIL 1:N CO Key Only ................. N
; INPUT >>
6) To store the new assignment to the system, at Input prompt
(INPUT >>), type:
; PRG > WS3 AT 03
; 3 : DTMF-Tone Integration............... N
; INPUT >> Y
; 1 : DIL 1:N CO Key Only ................. N
; INPUT >> $ EOD
This assigns the DTMF-Tone Integration feature to the system, and the
programming prompt (PRG>) appears on the screen again.
3-F-26
(↵ )
(↵ )
(↵ )