Audio Output; Standby Through - Yamaha RX-A1010 Owner's Manual

❑ ARC
Enables/disables ARC (p.25) when "HDMI Control" is set to "On".
Settings
Off Disables ARC.
On (default) Enables ARC.
• You do not need to change this setting normally. In case noises are produced from the speakers connected
to this unit because TV audio signals input to this unit via ARC are not supported by this unit, set "ARC" to
"Off" and use the TV speaker.
❑ Standby Sync
Select whether to set this unit to standby in conjunction with TV power-off when "HDMI
Control" is set to "On".
Settings
Does not set this unit to standby mode in conjunction with TV
Off
power-off.
Sets this unit to standby mode in conjunction with TV power-
On
off.
Sets this unit to standby mode in conjunction with TV power-off
Auto (default)
only when this unit is receiving TV audio or HDMI signals.
■

Audio Output

Selects a device to output audio.
• The "Amp" and "HDMI OUT1" settings are available only when "HDMI Control" is set to "Off".
❑ Amp
Enables/disables the audio output from the speakers connected to this unit.
Settings
Off Disables the audio output from the speakers.
On (default) Enables the audio output from the speakers.
❑ HDMI OUT1, HDMI OUT2
Enables/disables the audio output from a TV connected to the HDMI OUT 1 jack or
HDMI OUT 2 jack.
Settings
Off (default) Disables the audio output from the TV.
On Enables the audio output from the TV.
■

Standby Through

Select whether to output videos/audio (input through HDMI jacks) to the TV when this
unit is in standby mode.
Settings
Off (default) Does not output videos/audio to the TV.
Outputs videos/audio to the TV.
On
(This unit consumes approximately 3 W of power.)
• This setting is available only when "HDMI Control" is set to "Off".
110
En