Checking The Measurement Results; Reloading The Previous Ypao Results - Yamaha RX-A1010 Owner's Manual

1 2 3 4 5 6 7 8
Automatic speaker setup
MAIN MAIN ZONE 2 ZONE 2
CODE SET CODE SET
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
DOCK DOCK
MULTI MULTI PHONO PHONO
TUNER TUNER SIRIUS SIRIUS NET NET USB USB
CATEGOR CATEGORY A A Y
FM FM AM AM
PRESET PRESET TUN./CH TUN./CH
INFO INFO MEMORY MEMORY
SUR. DECODE STRAIGHT SUR. DECODE STRAIGHT
MOVIE MOVIE MUSIC MUSIC
SLEEP SLEEP PARTY ENHANCER ENHANCER ENHANCER PURE DIRECT P URE DIRECT
SCENE SCENE
ON SCREEN
1 1 2 2 3 3 4 4
BD/DVD BD/DVD TV TV CD CD RADIO RADIO
ON SCREEN OPTION OPTION
Cursor keys
ENTER VOLUME VOLUME
ENTER
RETURN RETURN DISPLAY DISPLAY A A
RETURN
TOP TOP POP-UP POP-UP
MUTE MUTE
MENU MENU MENU MENU
MODE MODE
HOLD TAG PRG SELECT
1 1 2 2 3 3 4 4
5 5 6 6 7 7 8 8
9 9 0 0 10 10 ENT ENT
TV
INPUT INPUT
TV VOL TV CH
HDMI OUT
MUTE MUTE
Now optimization of the speaker settings is complete.
Caution
• Since the YPAO microphone is sensitive to heat, do not place the microphone
in any place where it will be subjected to direct sunlight or high temperatures
(top of an AV equipment, etc).

Checking the measurement results

You can check the YPAO measurement results.
1
After the measurement, use the cursor keys to
select "Result" and press ENTER.
• You can also select "Result" from "Auto Setup" (p.102) in the "Setup" menu.
In this case, the previous measurement results are displayed.
The following screen appears.
1
1
Measurement result items
2
Measurement result details
3
The number of measured positions (when multi
measure is performed)
2
Use the cursor keys to select an item
Polarity of each speaker
Normal: The speaker cable is connected with the
Wiring correct polarity (+/-).
Reverse: The speaker cable may be connected with
the reversed polarity (+/-).
Size
Distance
Level
• A speaker with any problem is indicated with a red-boxed message.
3
To finish checking the results and return to the
previous screen, press RETURN.

Reloading the previous YPAO results

When the speaker settings you have configured manually are not
suitable, follow the procedure below to discard the manual settings
and reload the previous YPAO results.
2
1
In the "Setup" menu, select "Speaker", "Auto
Setup" and then "Result" (p.101).
3
2
Use the cursor keys to select "Setup Reload" and
press ENTER.
3
To exit from the menu, press ON SCREEN.
Size of each speaker (cross-over frequency of the
subwoofer)
Large: The speaker can reproduce low-frequency
signals effectively.
Small: The speaker cannot reproduce low-frequency
signals effectively.
Distance from the listening position to each speaker
Output level adjustment for each speaker
44
En