Network
Configures the network settings.
■
IP Address
Configures the network parameters (IP address, etc).
❑ DHCP
Select whether to use a DHCP server.
Settings
Does not use a DHCP server. Configure the network parameters
Off
manually.
Uses a DHCP server to automatically obtain the network parameters (IP
On (default)
address, etc.) of this unit.
❑ Manual Setup
Configures the network parameters of this unit manually when "DHCP" is set to "Off".
Submenu
IP Address
Specifies an IP address.
Subnet Mask
Specifies a subnet mask.
Default Gateway
Specifies the IP address of the default gateway.
DNS Server (P)
Specifies the IP address of the primary DNS server.
DNS Server (S)
Specifies the IP address of the secondary DNS server.
■
Network Standby
Selects whether to turn on this unit by the command from other network devices
(network standby).
Settings
Off (default)
Disables the network standby function.
Enables the network standby function.
On
(This unit consumes approximately 5 W of power.)
■
MAC Address Filter
Sets the MAC address filter to limit access to this unit from other network devices.
❑ Mode
Enables/disables the MAC address filter.
Settings
Off (default)
Disables the MAC address filter.
Enables the MAC address filter. In "Address Setup", specify the MAC
On
addresses of the network devices that will be permitted access to this
unit.
❑ Address Setup
Specifies the MAC addresses (up to 10) of the network devices that will be permitted
access to this unit when "Mode" is set to "On".
111
En