Yamaha RX-A1010 Owner's Manual page 18

1 2 3 4 5 6 7 8
Speaker connections
■
Connecting speakers
Connect the speakers placed in your room to this unit.
Caution
• Remove the power cable of this unit from an AC wall outlet and turn off the subwoofer before
connecting the speakers.
• Be careful that the core of the speaker cable does not touch anything or come into contact with the
metal areas of this unit. This may damage this unit or the speakers. If the speaker cables short circuit,
"CHECK SP WIRES" will appear on the front display when this unit is turned on.
Speakers to be connected
Room Speaker type Abbr.
Front (L)
Front (R)
Center
Surround (L)
Surround (R)
Surround
Main zone
back (L)
Surround
back (R)
Front
presence (L)
Front
presence (R)
If you have 7 speakers, use two of them as surround back speakers (*1) or front
presence speakers (*2).
• You can also connect up to 2 subwoofers (with built-in amplifier) to this unit.
• To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see "Connecting an
external power amplifier" (p.23).
Cables necessary for connection (commercially available)
Speaker cables (x the number of speakers)
+ +
– –
Audio pin cable (2 for connecting 2 subwoofers)
Speaker system
Power Amp
(the number of channels)
Assign
(p.104)
7+2 7 5 2
● ● ● ●
● ● ● ●
● ● ●
● ● ●
● ● ●
●
Basic (default)
*1
●
*1
●
*2
●
*2
Connection diagram
Refer to the following diagram and connect the speakers to this unit.
MULTI CH INPUT
ZONE OUT PRE OUT
CENTER
This unit (rear)
URROUND SUR. BACK SUBWOOFER ZONE 2 FRONT SURROUND
SPEAKERS
SURROUND SURROUND BACK
R L R
SINGLE
• When using only one surround back speaker, connect it to the SINGLE jack (L side).
(SINGLE)
1
2
SUR. BACK SUBWOOFER CENTER
CENTER FRONT ZONE 2/F.PRESENCE/
L R L R L
BI–AMP
EXTRA SP
17
En