Table of Contents
Advertisement
4-44
SPANNING OF RAID5
1.
Open the configuration creation screen.
Select "Configure" → "New Configuration" from the TOP menu to display the screen shown below. This is
the Channel-1 menu screen where the cursor is put on ID=0 position:
2.
Select ID-0/1/2 hard disks.
Pressing Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking.
(The cursor automatically moves to Channel-1, ID=1.) In the same way, press Space on Channel-1, ID=1.
(Where "A01-02" is blinking, the cursor moves to Channel-1, ID=2.) In the same way, press Space on
Channel-1, ID=2. (Where "A01-03" is blinking, the cursor moves to Channel-1, ID=3.) After selecting 3 hard
disks (Channel-1, ID=0/Channel-1, ID=1/Channel-1, ID=2), press Enter to determine the settings. (Display
on each hard disk stops blinking.)
Advertisement
Table of Contents
