Expressbuilder For Dos-Based With Local Console - NEC 140He User Manual

6-4

EXPRESSBUILDER for DOS-Based with Local Console

This subsection describes the procedures for using EXPRESSBUILDER for DOS-based with local console.
Starting EXPRESSBUILDER
The following procedure instructs you to start EXPRESSBUILDER.
IMPORTANT: Do not remove the EXPRESSBUILDER CD-ROM while
EXPRESSBUILDER is running.
1.
Turn on peripheral devices and the server in this order.
2.
Insert the EXPRESSBUILDER CD-ROM supplied with your server into the CD-ROM drive of your server.
3.
Ensure that the floppy disk drive is empty.
4.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the EXPRESSBUILDER. (You may
also turn off and then on again to reboot the server.)
EXPRESSBUILDER boots up displaying the top menu.