Operating Procedures For Configuration Utility - NEC 140He User Manual

4-34
IMPORTANT:
Notice status display of "Disable (Enable) BIOS".
Selected Enable : Indicate "Disable BIOS"
Selected Disable: Indicate "Enable BIOS"
When "Factory Default" is executed, the setting values are changed.
Set each parameter after executing "Factory Default."
Some versions of MegaRAID Configuration Utility change the "Factory Default"
setting value.
Check each parameter setting after executing "Factory Default."
The server must be restart after executing "Factory Default."

Operating Procedures for Configuration Utility

Creating/adding configuration
Set new configuration information (pack/logical drive settings)
Procedures
1.
Start MegaRAID Configuration Utility to check each setting parameter.
Select "Configure" → "New Configuration" from the TOP menu (Management Menu).
2.
Select "View/add Configuration" to add configuration.
IMPORTANT:
When a new configuration is created by selecting "New Configuration," the existing
configuration information is cleared. To add configuration information to that existing,
select "View/add Configuration."
"Easy Configuration" cannot set logical drive capacity or create SPANNING OF RAID1.
Select "New Configuration" or "View/add Configuration" to execute these.
3.
When a confirmation message (Proceed?) is displayed, select "Yes."
Start MegaRAID Configuration Utility
Check the logical drive settings
Initialize logical drive
Exit MegaRAID Configuration Utility