Table of Contents
Advertisement
9-34
(7)
Click [Finish].
(9)
Remove the rear access cover and locate the slot from which the board has to be removed.
NOTE:
Confirm that the PCI Slot Power lamp of the target PCI slot is off.
To stop the device driver using the PCI hot-plug switch:
(1)
Remove the rear access cover and confirm the slot to remove the PCI board.
(2)
Press the PCI hot-plug switch on the slot from which the PCI board is to be removed.
NOTE:
Confirm that the PCI Slot Power lamp of the target PCI slot is off.
2.
Disconnect all the cables from the PCI board.
3.
Push the tab to unlock it, slowly open the tab, then remove the PCI board.
IMPORTANT:
damage the tab.
Tab
Do not open the retention tab to 90 degrees or more. Doing so could
Lock (for long card)
Advertisement
Table of Contents
