Operating Procedures For Configuration Utility - NEC Express5800 140Rd-4 User Manual

4-32

Operating Procedures for Configuration Utility

Creating/adding configuration
Set new configuration information (pack/logical drive settings)
Procedures
1.
Start MegaRAID Configuration Utility to check each setting parameter.
Select "Configure" → "New Configuration" from the TOP menu (Management Menu).
2.
Select "View/add Configuration" to add configuration.
IMPORTANT:
When a new configuration is created by selecting "New Configuration," the existing
configuration information is cleared. To add configuration information to that existing, select
"View/add Configuration."
"Easy Configuration" cannot set logical drive capacity or create SPANNING OF RAID1.
Select "New Configuration" or "View/add Configuration" to execute these.
3.
When a confirmation message (Proceed?) is displayed, select "Yes."
4.
When SCAN DEVICE is started (scanning information is displayed at the bottom of the screen) and ends, the "New
Configuration - ARRAY SELECTION MENU" screen appears.
5.
Move the cursor onto the hard disk to be packed by using cursor key and then press Space to select the hard disk.
(The display for the selected hard disk changes from READY to ONLIN and Axx-xx blinks.)
Start MegaRAID Configuration Utility
Check the logical drive settings
Initialize logical drive
Exit MegaRAID Configuration Utility