NEC Express5800 140Rd-4 User Manual page 88

4-6
To enable/disable the POWER switch and SLEEP switch
To disable
Select [Security] - [Power Switch Inhibit] - [Enabled].
To enable
Select [Security] - [Power Switch Inhibit] - [Disabled].
IMPORTANT:
well as power on/off using the POWER switch.
To set the secure mode
Select [Security] - [Secure Mode] and set each item.
External Devices
To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To set up internal PCI devices of the server
Select [Advanced] - [PCI Configuration] and set up each device.
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes].
PCI Hot Plug
To install the PCI board with the PCI hot plug
Select [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] - [Minimum/Middle/Maximum*]
* The setting varies depending on the PCI board subject to the hot plug. See the table below.
Board name
100BASE-TX Adapter
1000BASE-T Adapter
1000BASE-TX Adapter
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] - [Exit Saving Changes] or [Save Changes].
To discard changes to the BIOS configuration data
Select [Exit] - [Exit Discarding Changes] or [Discard Changes].
To resume the default BIOS configuration data (may differ from factory-set value)
Select [Exit] - [Load Setup Defaults].
To save the current value as user default
Select [Exit] - [Save Custom Defaults].
To load the user-defined default
Select [Exit] - [Load Custom Defaults].
Enabling [Power Switch Inhibit] disables forced shutdown (see Chapter 8) as
Setting Value
Minimum
Minimum
Minimum