NEC Express5800 140Rd-4 User Manual page 113

Setting values
No. Setting parameter
*1 FlexRAID PowerFail
*2 Fast Initialization
*3 Disk Spin-up Timing
*4 Cache Flush Timing
*5 Rebuild Rate
*6 Alarm Control
*7 Disable(Enable) BIOS
*8 Emulation
*9 Auto Rebuild
*10 Cluster Mode
*11 Multiple PCI Delayed Trans
*12 Force Boot
*13 Coercion Algorithm
*14 CC Restoration
*15 Temporary Offline RAID
*16 Synchronous Negotiation
*17 SCSI Command Q Tagging
*18 Termination State
*19 Enable Auto Termination
*20 SCSI Transfer rate
Changing factory settings
The settings for the following items can be changed. Follow each explanation:
*2 Fast Initialization
*5 Rebuild Rate
*14 CC Restoration
IMPORTANT:
Notice status display of "Disable (Enable) BIOS".
Selected Enable : Indicate "Disable BIOS"
Selected Disable: Indicate "Enable BIOS"
When "Factory Default" is executed, the setting values are changed.
Set each parameter after executing "Factory Default."
Some versions of MegaRAID Configuration Utility change the "Factory Default" setting value.
Check each parameter setting after executing "Factory Default."
The server must be restart after executing "Factory Default."
Factory setting
ENABLED
ON
2 disks every 6 seconds
Every 4 Seconds
30%
Disable Alarm
Enable (Display: Disable BIOS)
MASS STORAGE
ENABLED
DISABLED
ENABLED
ON
NONE
ENABLED
ENABLED
Enabled
Enhanced QTAG Scheduling
Enabled
No
320M
A setting of "On" is recommended.
This initializes the top area of the disk only.
A setting of "30%" is recommended.
Factory setting is "ENABLED".
Setting change
Do not change
Variable setting
Do not change
Do not change
Variable setting
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
Variable setting
Do not change
Do not change
Do not change
Do not change
Do not change
Do not change
4-31