Updating The System - Applying Service Pack; Upgrade Installation - NEC Express5800 140Rd-4 User Manual

A list of mass storage devices is displayed.
Select the [LSI MEGARAID Products for Windows 2003 (x86)] and press Enter.
Continue performing tasks according to the subsequent messages that appear.
For details, refer to "Getting Started".
After installation is completed, be sure to execute the tasks described in "Driver Installation and Advanced Settings" and
"Updating the System" of this manual.
Procedure for License Authentication
Product Key used in the procedure for license authentication should be matched with the COA label in which the product key
contained in Windows Server 2003 is written.
NOTES:
Execute the activation within 30 days. System may be locked after 30 days is passed.
COA label may be attached to your server.

Updating the System - Applying Service Pack -

IMPORTANT:
your system, you do not have to apply Service Pack 1 again.
To ensure normal system operation you should update your system using the following procedures.
1.
Logon to the system using the administrator account or other account which is a member of the Administrators
group.
2.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive.
Master Control Menu is automatically appeared on the screen.
3.
Click [Setup] with left mouse button and click [Update Express5800 system] section.
4.
Continue your work for system update as the following message.
5.
Click [Restart Computer] to restart the system.
6.
Remove the EXPRESSBUILDER CD-ROM from the CD-ROM drive immediately after clicking [Restart Computer]
IMPORTANT: If you change the configuration of the system (by adding or removing hardware or
Operating system software components) or repair the system, you must run the system update
again.

Upgrade installation

NOTE:
Please do the upgrade installation after deleting the graphics accelerator driver.
1.
Procedures below upgrade the installed Windows 2000 to Windows Server 2003.
2.
Power on the system and start Windows 2000.
3.
Log on as an administrator.
4.
Insert the Windows Server™ 2003 CD-ROM into the CD-ROM drive.
Then, [Select an operation] dialog will appear.
If you install Windows Server 2003 CD-ROM which contains Service Pack 1 to
E-5