NEC Express5800 140Rd-4 User Manual page 290

9-42
Keep the removed blank cover for future use.
6.
Push the DIMM straight into the socket (2).
NOTE:
Make sure of the orientation of DIMM. The terminal side of the DIMM has cut-out to
prevent incorrect insertion.
The lever s automatically close when the DIMM is inserted into the socket (3).
IMP ORTANT:
specification. DIMM specification is shown on the label attached to the DIMM as follows:
Example: Frequency of 400 MHz, buffered, capacity of 1GB, row
address of 14 bits, column address of 11 bits, and
single rank
2-400 / B / 1024 / R14 C11 S
Buffered / Registered
Frequency
7.
Install the memory board back into the chassis slot.
8.
Install the memory slot cover and front bezel.
9.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error messages listed in Chapter 8.
Start the SETUP and select [Advanced] → [Memory Configuration] to
10.
status "Normal". (See Chapter 4 or details.)
11.
Se ct "Yes" for [Reset Configuration Data] on the [Advanced] men le
Th s setting is required to change the hardware configuration i
12.
If W indows Server 2003 or Windows 2000 is in use, set the paging file size to the recomm
size * 1.5) or a greater value. See Chapter 5 for details.
Always install the DIMMs in pair
Single rank
Column address
Row address
Capacity
. Two DIMMs must be of the same
ve rify that the installed DIMM shows the
u.
data. See Chapter 4 for details.
ended value (total memory