NEC Express5800 140Rd-4 User Manual page 271

Non-hot-plug PCI Boards
T his section describes the procedure of insta
In tallation s
T ake the following s teps to install a board in a PCI board slot.
IMPORTANT:
PCI board slots #6 to #9 can accept 3.3V and universal PCI boards.
P CI board slots #1 and #2 can accept 5
NOTES:
Before installing the PCI board, make sure that the terminal section of the board mates with the
connector of the PCI board slot.
T he insulators are
a lready been insta
r emoving the PCI board. If the insulator is taken off, reinstall the insulator in place.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
IMPOR TANT:
installing the non-hot swap board.
2.
Pull out the server from the rack.
3.
Remove the rear access cover.
4.
Locate th e slot to install a board.
5.
Press the retention tab at the tip of the additional slot c
IMPORTANT:
tab.
6.
Remove the blank plate.
IMPORTANT:
lling or removing a non-hot-plug PCI board.
V and universal PCI boards.
installed between the PCI board slots. They are for protecting the PCI board
lled. Take care not to remove or damage the insulator when installing or
To avoid damage to the system and devices, always turn off the system before
Do not open the retention tab to 90 degrees or more. Doing so could damage the
Keep the blank plate being removed for future use.
over to unlock and open the tab.
9-23