NEC Express5800 140Rd-4 User Manual page 55

Windows server 2003 x64 editions
Hide thumbs Also See for Express5800 140Rd-4:
Table of Contents

Advertisement

NOTE:
The operation or utility to be started at each key entry is described below. These
oper
ations or utilities may not always be started.
E
sc
Press
Esc to displa
b
oot device.
F2
Press F2 to start the BIOS setup utility. Start the utility to change the setting of the server in
order to fit to the environment in which the server is used. This setting needs not be changed,
unless it is displayed along with an error message. See Chapter 4 for the setting procedures and
fe
atures of
the parameters.
F4
F4 to start the Off-line Maintenance Utility from the maintenance partition. See Chapter
Press
6 for
the maintenance partition.
F12
F12 to run the network boot.
Press
F
1
If me
ssage "Press <F1> to resume" appears, an error is detected during POST. See "Error
mess
ages during POST" for the information o
errors.
If an error m
7.
When a passw
ord is set in the BIOS setup utility SETUP,
after the norm
al ter
mination of POST.
The passwor
d can be entered for up to three times. If you enter the password incorrectly all the time, the server
cannot be sta
rted. In this case, turn off the power of the server, wait for about 10 seconds, and then turn on the power
to start the se
rver again.
IMPORTANT:
8.
St ts operating system at the termination of POST.
ar
POST Erro
r Messages
When POST
detects an error, it displays an e
IMP
ORTANT:
representative. Alarm messages are useful information for maintenance.
y the boot menu at the end of POST. This menu allows you to select the
Boot Menu
1. CD-R
OM Drive
2. +Rem
ovable Devices
3. +Hard
Drive
4. IBA G
E Slot 0B20 v1222
5. IBA G
E Slot 0B21 v1222
<Enter Setup>
essage appears, pressing
Set the password only after operating system is installed.
rror message on the display unit screen. See Chapter 8 for POST error codes.
Take a note on the messages displayed before consulting with your service
n the messages and the proper actions against the
F1 allows the BIOS setup utility to be started.
the screen prompting you to enter the password appears
2-25

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents