Server ~ Pulling Out From The Rack Cabinet - NEC Express5800 140Rd-4 User Manual

9-12

Server ~ Pulling Out from the Rack Cabinet~

T he server needs to be pulled out from the rack for installing/removing any com
po wer supply units.
Observe the following instructions to use the
result in death or serious personal injury. See pages 1-3 to 1-8 for details.
Do not install the server on a rack with leaving covers removed.
Do not pinch your finger with mechanical components.
N te o high temperature.
Do no pull out a device from the rack if the rack is unstable. t
Do not leave more than one device being pulled out from the rack.
1.
See the section " Preparing for Installation and Removal" described earlier to prepare.
2.
Remov he fron e t t bezel.
3.
Loosen the four screws from the front of the server.
Screws
4.
Slowly pull out the server
heard.
When inserting th e server back into the rack, push the release levers on the rails on the sides of the server to unlatch the server.
Be very careful not to get your finger caught in doing so.
IMPORTANT:
finger may hurt your finger.
CAUTION
frame
Tab
from the rack while pushing the release lever. The server is latched when a "click" is
Push the release lever using a screwdriver or the like. Pushing the lever with your
ponents other than the hard disk drives and
server safely. Failure to fo llow these instructions may
Screws