NEC Express5800 140Rd-4 User Manual page 168

5-14
Graphics Accelerator Driver
Standard graphics accelerator drivers that are mounted will be installed automatically. The following is the procedure when it
is necessary to install manually.
If you want to use an optional Graphics Accelerator Driver board, follow the document attached to the board to install the
driver.
1.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive.
2.
Click Start menu, point to [Programs], [Accessories] and click [Windows Explorer].
3.
Run "SETUP.EXE" in the following directory.
<CD-ROM Drive Letter>:\WINNT\DOTNET\VIDEO\SETUP.EXE.
4.
Follow the message to continue the installation.
If the dialog message "Digital Signature could not been found." appears, select [Yes] to continue.
5.
Remove the EXPRESSBUILDER CD-ROM from the CD-ROM drive, follow the direction on the screen and restart
the system.
Available switch options for Windows Server 2003 Boot.ini file.
Many different switches will be available if you edit Boot.ini file.
For the available switch options, refer to the following information:
Microsoft® Knowledge Base - Article ID: 833721
"Available switch options for the Windows XP and the Windows Server 2003 Boot.ini files"
If your system has a memory capacity in excess of 4 GB in its installing, adding /PAE switch in Boot.ini file will enable the
system to be installed with over 4 GB of memory.
However, the Microsoft operating system products which support /PAE switch option are limited.
Refer to the following article in Microsoft Knowledge Base to check the supported products.
Microsoft Knowledge Base - Article ID: 291988
"A description of the 4 GB RAM tuning feature and the Physical Address Extension switch"
Below is the example on how to add /PAE switch to Boot.ini file.
1.
Click [Start], point to [Settings], and then click [Control Panel].
2.
In [Control Panel], double-click [System].
3.
Click the [Advanced] tab, and then click [Settings] under [Setup and Recovery].
4.
Under [System Setup], click [Edit] to open [Boot.ini].
5.
Add "/PAE" to [Operating Systems] section in [Boot.ini] file, and then save it.
<Example of Boot.ini file>
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(2)\WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows Server
2003, Standard" /fastdetect
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows Server
2003, Standard, PAE" /fastdetect /PAE
C:\CMDCONS\BOOTSECT.DAT="Microsoft Windows Recovery Console" /cmdcons
This is the end of editing Boot.ini file.
NOTE: If you choose one of the items in the "Default operating system" drop-down list box in
[Setup and Recovery] group box, you can make your system start automatically from the switch
you specified.