Digital Instrument, Warning Lights (Te-Smr) - Husqvarna TE 250 Workshop Manual

Digital instrument, warning lights (TE-SMR)

The motorcycle is equipped with a digital instrument; on the instrument are
located 5 warning lights too: high beam, lights (with display lighting), blinkers,
neutral and fuel reserve.
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "LIGHTS"
3- GREEN warning light "BLINKERS"
4- GREEN warning light "NEUTRAL"
5- ORANGE warning light "Fuel reserve"
- After the engine starting, for the first 2 seconds, the instrument
shows the version of the checking SW; after the check, the instrument
shows the last planned function.
- When the motorcycle engine is OFF, the instrument doesn't also
show its functions.
- To select the instrument functions and to set to zero the functions,
use the SCROLL knob (A).
IMPORTANT: Functions of the GREEN warning light (4) "NEUTRAL" in case
of FUEL INJECTION SYSTEM malfunction (contact your local HUSQVARNA
Dealer)
a) With the GEARBOX NOT in NEUTRAL position: the warning light FLASHES
INTERMITTENTLY.
b) With the GEARBOX in NEUTRAL position: the warning light is initially
constantly ON then it FLASHES
TWICE IN RAPID SUCCESSION then returns to being constantly ON. This
cycle repeats itself. After eliminating the malfunction, the warning light (4)
returns to its normal operation.
- The instrument functions are the following, as shown below.
1- SPEED / ODO (figure 1)
2- SPEED / H (figure 2)
3- SPEED / CLOCK (figure 3)
4- SPEED / TRIP 1 (figure 4)
5- SPEED / STP 1 (figure 5)
6- SPEED / AVS 1 (figure 6)
7- SPEED / SPEED MAX (figure 7)
8- SPEED / TRIP 2 (figure 8)
9- SPEED / TRP 2 / CLOCK (figure 9)
10- SPEED / RPM (engine r.p.m. numerical value) (figure 10)
1- SPEED / ODO (figure 1)
.................
:The RPM function, shown on the vertical LED indicator, is ALWAYS on.
1- SPEED (kmh or mph) / ODO / RPM (figure 1)
- SPEED: motorcycle speedmaximum value: 299 kmh or 299 mph;
- ODO: odometer- maximum value: 99999 km;
- RPM: engine r.p.m. shown on the vertical LED indicator.
To replace kilometers with miles or miles with kilometers proceed as follows:
1) set to figure 1, stop the engine and push the knob SCROLL (A).
2) start the engine while pushing for 3 seconds the knob SCROLL (A).
After the kilometers-miles or miles-kilometers setting operation, for 3 seconds,
"SET" and miles/mph or km/kmh will be on.
After the previously described operation, the ODO setting will be
convert and all the others data will be reseted (the H Counter is unchanged).
Part. N. 8000 B0148 (02-2008)
ELECTRIC SYSTEM, DIGITAL INSTRUMENT
M.37
2
1
4 3
A
5
A