Preliminary Operations; Removing The Front Wheel - Husqvarna TE 250 Workshop Manual

STEERING HEAD TUBE ADJUSTING INSTRUCTIONS
The supplied kit consist of 9 bushes (+2 standard, assembled onto the steering head tube) identified by the two marks "A" on bottom side:

PRELIMINARY OPERATIONS

Removing the Front Wheel

Set a stand or a block under the engine and check that the front wheel is lifted
from the ground. Remove the two brake caliper fastening screws (1). Loosen
the bolts (2) holding the wheel axle (a) to the front fork stanchions. Hold the
head of the wheel axle on R.H. side, then unscrew the bolt (3) on the L.H. side;
strike the wheel axle with a nylon drift and draw the wheel axle out. To reassem-
ble, reverse the above procedure remembe-ring to insert the disc into the caliper.
Notes
Do not operate the front brake lever when the wheel has been removed;
this causes the caliper piston to move outwards. After removal, lay down
the wheel with brake disc on top.
Part. N. 8000 B0148 (02-2008)
SMR 450-R
Part No. Q.ty
8000 B1781 2
8A00 B1781 1
8B00 B1781 2
8C00 B1781 2
8D00 B1781 1
8E00 B1781 1
8F00 B1781 1
8G00 B1781 1
R.5
Mark "A"
80 (standard)
8A
8B
8C
8D
8E
8F
8G