Husqvarna TE 250 Workshop Manual page 351

"KIT" ASSEMBLING INSTRUCTIONS
6- Blinkers Kit (TE-SMR)
FRONT TURN SIGNALS
Remove the two fastening elastics (A) and the headlamp holder. Assemble the
turn signal (1) on the plate (4) fastening with the nut (6) M6, then pass the cable
(B) trough the plate front hole. Remove the steering head fastening screws (B)
and assemble the plate complete with turn signal using the same screws (4) and
the corresponding spacer (5) (R.H. side: remember to assemble the horn (C) too,
between the turn signal plate and the steering head). Connect the turn signals to
the main wiring harness. Regarding the correct connection to the main wiring
harness, see the wiring diagram (page O.11).
The description refers to the assembly of the left turn signal (1), the
assembly of the right turn signal is symmetrical.
BLINKERS KIT
1- Front left and rear right turn signal (2)
2- Rear left and front right turn signal (2)
3- Front right plate (1)
4- Front left plate (1)
5- Front spacer ø12xø20x8,5 (2)
6- Nut M8 (4)
7- Elastic washer (4)
8- Flasher
C
5 B
3
1
6
7
B
5
4
Part. N. 8000 B0148 (02-2008) O.9