Husqvarna TE 250 Workshop Manual page 48

SETTINGS AND ADJUSTMENTS
Put the drum stop hub (22) on the clutch hub (1) with a small quantity of grease;
- insert the toothed washer (23) with the convex side facing upward;
TOOLS
- mount the spring (7) in its seat inside the drum (1) with a small quantity of grease;
- insert the plate (6) on the drum (1);
- arrange the shim (25) in the plate (6) and insert the spring (26);
- insert the spring retainer plate (27) into the spring (26) with the splined side
facing upward so that the 9 tabs match the 9 spokes of the spring (26). Insert the
thrust bearing (28) and the spring stop hub (29);
- insert the tool provided (a) in the seat on the hub (29) and use the 27 mm wrench
(c) and the tool (b) no. 8000 A8190 to screw the spring stop hub (29) onto the main
shaft (75 Nm- 7.6 Kgm- 55 ft/lb);
- mount the washer (12), the nut (11) and the pin (31) and place the support (30)
along with the fifth wheel (33) and the thrust bearing (32) into their seat in the
pressure plate (6), making sure it is properly inserted in the appropriate splines
and fix it with the 6 screws (9) and their notched washers (8);
- tighten the screws (9) crosswise and gradually with a 4 mm Allen wrench (6 Nm-
0,6 Kgm- 4.4 ft/lb).
- mount the clutch cover and tighten its screws (A) (11 Nm-1,1 Kgm- 8.1 ft/lb).
Check screw tightening (1) every 2 hours.
D.14 Part. N. 8000 B0148 (02-2008)