Toshiba TDP-SW20 Service Manual page 78

Solution 16 ・ As for the spec. of PC, the following value is recommended. CPU is more than Pentium III 750MHz,
memory is more than 256MB, and resolution of a screen is XGA (1024x724 pixels).
・ Display speed may become slow if resources run short for the reason of using application in large
quantities. Please do not use unnecessary application.
When there is change to the contents of a display at high speed over the range with large PC screen,
・
the amount of communication data increases and display speed may fall.
Solution 17 ・ After Wireless Utility is chosen as a transmission image and the transmission is started, if Wireless
Utility is minimized and stored in a task tray, connection will stop (specification). Please push the
[Advanced...] button in the main window of Wireless Utility, remove the check [Place in task tray at
the start of transmission], and do not minimize it.
Solution 18 Please set up a wireless LAN setting of the projector / PC / access point.
・
Solution 19 Please install apparatus in the range which the electric wave of wireless LAN reaches.
・
・ Even if there are some obstacles, communication is possible, but please install apparatus in the good
place of a prospect.
・ Please change the channel setting, in order to avoid interference of the electric wave. (Don't use the
adjoining channel.)
[Note] After turning OFF the power supply of the other apparatuses which operate by the same SSID
・ When the apparatus (other IEEE802.11b/g or Bluetooth apparatus, a microwave oven, etc.) which
uses the frequency of a 2.4GHz bandwidth for the circumference exists, communication may not
work.
Solution 20 Please replace the wireless LAN PC card of projector attachment.
・
Solution 21 Please replace the substrate of the network unit.
・
Solution 22 It is thought that a cause is in the affinity of a wireless LAN device. Please use the other network
・
devices (wireless LAN
(after the apparatus which operates by the target SSID is set only to one), it is necessary to
change the channel setting.
PC card etc.) by the PC side, or use the other access point, and try again.
78