Toshiba TDP-SW20 Service Manual page 82

Solution 23 ・ It is necessary to communicate by IEEE802.11b or IEEE802.11g.
・ When using a wireless LAN PC card, please attach the card correctly to PC and enable the wireless
function. (Please refer to the manual of a wireless LAN PC card for details.)
When using a built-in wireless LAN, please enable the wireless LAN function of PC, according to the
・
manual of PC.
Solution 24 Please check the setting of the network or wireless LAN.
・
Solution 25 Please attach a LAN cable to PC and enable wired LAN.
・
Solution 26 ・ Cannot communicate when there are not PC and a projector in the same sub-network. Please set up
TCP/IP setting anew.
Solution 27 ・ Please permit access from the MAC address of the wireless LAN PC card of the projector attachment
by the setting of the access point. (When using the built-in wireless LAN for PC side, please permit
access from the MAC address of the wireless LAN device of PC)
(Please refer to the manual of the access point for details.)
Solution 28 Please check the IP address on the Status display screen of the Wireless/Card menu of the projector.
・
・ The IP address should differ from the apparatus which exists in the circumference.
Solution 29 ・ By the setting of IE, in accessing URL of the projector, please set up not to use a proxy.
Solution 30 ・ Please install apparatus in the range which the electric wave of wireless LAN reaches.
・ Even if there are some obstacles, communication is possible, but please install apparatus in the good
place of a prospect.
Please change the channel setting, in order to avoid interference of the electric wave. (Don't use the
・
adjoining channel.)
[Note] After turning OFF the power supply of the other apparatuses which operate by the same SSID
When the apparatus (other IEEE802.11b/g or Bluetooth apparatus, a microwave oven, etc.) which
・
uses the frequency of a 2.4GHz bandwidth for the circumference exists, communication may not
work.
Solution 31 ・ Please replace the wireless LAN PC card of projector attachment.
Solution 32 ・ Please replace the network board.
Solution 33 ・ It is thought that a cause is in the affinity of a wireless LAN device. Please use the other network
devices (wireless LAN PC card etc.) by the PC side, or use the other access point, and try again.
(after the apparatus which operates by the target SSID is set only to one), it is necessary to
change the channel setting.
82