B7.2 Port Setting - Panasonic KX-TVS50 Installation Manual

B7.2 Port Setting

To select Port Setting, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2
Port Setting Menu
To select the Port Setting Menu for Port 1, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2 - 1
Parameter
Flash Time
CPC Signal
Disconnect
Time
Dial Mode
Note
The port assignment procedure for Port 2 is the same as Port 1.
SYSTEM ADMINISTRATOR'S GUIDE
Value Range
(Default)
1. 100 ms Specifies the length of time the hook switch must be
2. 300 ms pressed before the PBX will recognize it as a flash hook
3. 600 ms signal. See the PBX manual to determine the correct
4. 900 ms value.
(600)
1. None Specifies the minimum time necessary to detect an
2. 6.5 ms interruption in the CPC (Calling Party Control) signal
3. 150 ms received from the PBX. The VPS is able to determine
4. 300 ms
that the line has been disconnected when an
5. 450 ms interruption of the CPC signal has been detected.
6. 600 ms
(None)
1-8 s Specifies the length of time the line is temporarily
(2) unavailable after a call has ended.
1. DTMF Specifies the dial mode for DTMF or Pulse. If Pulse is
2. Pulse 10 pps specified, pulse speed (10/20 pps) must be selected.
3. Pulse 20 pps
(DTMF)
Note: This setting only affects outward dialing from the
VPS. The VPS can only receive DTMF signals.
B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
Table 64
Description/Function
247