Sanyo sfx-32 Instruction Manual page 93

92
Troubleshooting
If problems occur during operation, check below before taking the unit for service. If the problem cannot be
corrected, contact the dealer from whom the unit was purchased.
Symptoms
Possible Causes/Solutions
Page
Unit does not operate.
AC plug may not be connected to electrical outlet.
8
—
The display indicates CHECK
Recording paper may not be set properly.
PAPER ROLL
10
~
Recording paper may have run out.
al
c
6
Document cannot be insered. Document may be too thin or too thick.
20
Another document may be jammed inside. Open operation
panel and remove jammed document. You may have placed
88
more than 10 sheets.
G
Transmission is not possible.
Document may not be inserted enough into the slot.
21
.-
; .-
E
Recording paper may have run out on receiving unit.
—
@
c
E
Receiving unit may be set for manual reception.
30
Reception is not possible.
Unit may be set for manual reception. Just lift the handset.
(Bell rings).
Incoming fax transmission can be received without pressing 30
ml key.
AC cord may not be connected. 8
Recording paper may have run out.
10
—
Reception is not possible. Closed network communication may be on. Check feature 85
c
switch No. 26.
0 .=
a
Recording paper may have run out. 10
I
a
Received copy is not dark
The recommended recording paper is not used. 10
enough.
Transmitted original may be light. 21
Received copy is blank.
Recording paper may have been inserted upside-down.
Transmitted original may have been upside-down.
10
Received copy contains illegible/
Phone connection may have been poor. (If problem con-
distorted characters.
tinues, contact dealer.)
—
Red line appears on recording Recording paper has almost run out.
paper. Install a new recording paper roll.
10
Error lamp lights.
Press ~P/C] to turn off the ERROR LIGHT.
$E
Print an Activity Report.
55
Check the ERROR CODE.
11