Connecting Led And Sata Cables; Led Cable Connection Table - NEC Promise SuperTrak EX8350 User Manual

24

5-4. Connecting LED and SATA Cables

Connect the LED cable coming with the server to the HDD LED connector. For the connection, see the figure
and the connection table below. For the connection to the motherboard, refer to the User's Guide of the
server. If it is hard to connect the LED cable, pull out the card from the PCI (or PCI Express) slot once and
connect the cable to the card.
Next, connect a SATA cable to the SATA connector on the card. The port number of the SATA cable should
be the same as that of the card.
Connect the black
cable to this pin.
LED cable

LED cable connection table

HDD LED
connector
Notice
Connect the red cable to this
pin. (This is not used for a
single-line LED cable.)
1 2
HDD LED connector
SATA cable
2-line cable
Pin 1 Connected with black cable
Pin 2 Connected with red cable
Depending on the type of the server, the LED cable has two lines or only
a single line.
To use the SATA2 HDD Cage, connect the SATA cable coming with the
cage to the card. For the detailed connection, refer to the User's Guide
of the additional HDD cage.
To connect with the rack-mount type server, use the SATA cable coming
with the server. Refer to the User's Guide of the server for details.
LED cable (coming with server)
1-line cable
Connected with black cable
Not used