Table of Contents
Advertisement
56
Write Through
Gigabyte Boundary
This feature is fixed to "No" and cannot be changed.
Upon completion of setting, move cursor to [Save] and press the <Enter> key to save the
7.
configuration data.
When the configuration data is successfully saved, the screen returns to [Logical Drive
8.
Management]. Check the status of the logical drive you have created. If you are going to create
another logical drive, select [Create] and repeat Steps 3 through 7 described above.
When you have configured all logical drives, exit from SuperBuild Utility and restart the server.
9.
On the POST screen, make sure that "Ok" is indicated in "Status" field.
10.
Example: Logical drive configured with four HDDs and in RAID5 level.
S u p erTrak E X 16350/16300/8350/8300(S ATAII 300) B IO S Version x.x.xxxx.xx
(c) xxxx-xxxx P ro m ise Tech no lo g y, In c. All righ ts reserved .
C o n troller 1 :
ID
L og ical D rive N am e
1
L og ical D rive 1
cache memory. The access performance is improved compared with
the Write Through mode. However, if an accident such as
instantaneous power failure occurs, the data may be lost.
This control method writes data into both cache memory and HDD
simultaneously. The access performance is not good as in Write Back
mode.
C apacity
749.80 G B
Statu s
O k
Advertisement
Table of Contents
