4.3
Installing HiPath 3750, HiPath 3700
4.3.1
Installation Prerequisites
Warning
7
Only authorized service personnel should install and start up the system.
Tools and resources needed
The following are needed for installing the HiPath 3750 and HiPath 3700 system:
Tools:
●
–
Hex or open-end wrench, 8 mm
–
Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
–
Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
–
Phillips or cross-point screwdrivers, sizes 1 and 2
–
TORX screwdriver
–
Wire stripper (for example, from Krone)
–
Electric drill, hammer
–
Level, tape measure
–
For U.S. only: Punch-down tool suitable for the block used (such as block 66)
Resources:
●
–
Assistant T or HiPath 3000 Manager E
–
Digital multimeter for testing ground connections and partial voltages
–
Telephone test set for analog interfaces
–
Not for U.S.: ISDN tester (such as K3000 or Aurora)
–
For U.S. only: Aurora
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Duet
Expert,
, Aurora
Aurora
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
Remote
or similar, ISDN protocol analyzer
inst_h3.fm
4-83