ABB i-bus KNX Product Manual page 19

®

i-bus KNX
The process to add a device is quite simple and can be done in two different ways:
a. Manually: You only have to look into the list for the EnOcean device family of the
device to be added, then select the device and finally click on the Add Device Node
button.
To add new devices just repeat the process as many times as EnOcean devices you
want to integer or simulate.
b. Remotely: Press Discover Device button on the plugin and then press the Teach-
in/learning (LRD) button on the EnOcean device that you want to integrate.
Remember that this function is only available for the integration of EnOcean devices
and not for the simulation scenario.
Please, keep in mind that rocker buttons need a specific operation when Teach-in, as
A0 button of the rocker needs to be pushed to ensure proper switch position is
configured (see Figure 5.6).
To add another device, click again on the teaching/learning (LRD) button. Once you
finish adding devices, click on the Done button if you don't want to wait for the
countdown to finish.
To erase an EnOcean device you have to select it in the plugin tree-view and click on the
Remove Device Node button. The plugin will ask you for confirmation.
In case you want to erase all the devices and device nodes, click on the Reset Configuration
button. This action will erase all current configuration including devices, device nodes and
chipID information.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
 +49 (0) 6221 701 724
EG/A 32.2.1
Button A0 Button B0
Button A1 Button B1
Figure 5.6 Indication on a rocker ChipID addition
Figure 5.7
Confirm erasing an EnOcean device screen
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
18 / 47