ABB i-bus KNX Product Manual page 26

 ®
i-bus KNX
If devices are learned before countdown reaches the end, you can press the
Done button so the countdown stops.
When the arrow is in the opposite directions (see
device is simulated, so instead of learning the device it has to be taught. To do
it so, press the arrow. Then a pop-up message will appear indicating that you
have to press the Learn button of your EnOcean device and after that the
information of the KNX/EnOcean Gateway will be taught and stored in the
EnOcean device.
 Erase: When pressing on the trash icon a new window will pop-up (see
5.22
will be able to delete each Chip ID individually. Remember to press the Save
changes button before closing the window.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
EG/A 32.2.1
). On this screen, user will see all Chip IDs from the associate node and
 +49 (0) 6221 701 724
Figure 5.20 Learning process
Figure 5.21 Teach-in process
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
), implies that the
Figure 5.21
Figure
25 / 47