ABB i-bus KNX Product Manual page 24

 ®
i-bus KNX
Upload chipIDs: When pressing this button, information regarding Chip IDs stored in
1
the Gateway is sent to the ETS plugin. A progress bar message will appear indicating
the uploading status.
Once information is imported a finish message will pop-up, indicating successful
results for the operation.
This step has to be performed every time a device (or devices) is (are) added or
erased using the gateway and you want them to be shown in the plugin.
Download chipIDs: When pressing this button, information regarding Chip IDs
2
stored in the ETS plugin is downloaded to the gateway. If gateway parameters were
not synchronized, the plugin will ask the user to synchronize information at both sides
before proceeding with Chip ID downloading.
Text below the button indicates whether information in the ETS has been
synchronized or not with the information in the gateway. If information is not
synchronized, text will appear red (see
between plugin information and gateway information.
As well as with the Upload chipIDs button, during downloading process a window will
pop-up indicating the uploading status.
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607
EG/A 32.2.1
Figure 5.13 Uploading Chip ID
Figure 5.14 Confirmation message after Chip ID upload
Figure 5.15 Devices data not synchronized message
Figure 5.16 Chip IDs not synchronized message
Figure 5.17 Downloading Chip ID
 +49 (0) 6221 701 724
) indicating there is no synchronism
Figure 5.16
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
User's manual r1.5 eng
23 / 47